WEEE Collection Rate at Just 28.7%: What the Figures Mean for Businesses
Germany falls significantly short of the European collection target. At the same time, practical experience shows that the underlying reporting data does not always provide a complete picture.
Germany continues to fall significantly short of the European collection target for waste electrical and electronic equipment (WEEE). For 2024, the German Environment Agency (Umweltbundesamt) reports a collection rate of just 28.7%, compared to the minimum target of 65% that has applied since 2019.
These figures highlight a clear need for action in the take-back and collection of WEEE. At the same time, it is worth taking a closer look at how the collection rate is calculated and the role that data quality plays in determining the results.
What Is Germany's WEEE Collection Rate?
In 2024, approximately 920,000 tonnes of WEEE were collected in Germany. This corresponds to a collection rate of 28.7%, significantly below the European target of 65%. The rate is also expected to remain at this level for 2025, as confirmed by stiftung ear in its information bulletin dated October 5.
Germany's low collection rate is also attracting attention in discussions at European level. However, it is important to look beyond the headline figure and consider the data on which the calculation is based.
How Is the Collection Rate Calculated?
The collection rate is calculated by comparing the weight of WEEE collected in a given year with the average weight of electrical and electronic equipment (EEE) placed on the market during the three preceding years.
This means that the collection rate is influenced not only by the amount of WEEE actually collected, but also by the reported quantities of electrical and electronic equipment previously placed on the market.
What Are the Main Reasons Behind the Low Collection Rate?
According to stiftung ear, three main factors contribute to Germany's low WEEE collection rate:
-
the rapid growth of photovoltaic installations, which increases the weight of equipment placed on the market without generating corresponding waste volumes in the short term;
-
longer product lifespans due to extended use and repairs;
-
exports of used electrical equipment, which are consequently not collected as WEEE in Germany.
These factors can lower the calculated collection rate without necessarily indicating shortcomings in the take-back system.
Why Data Quality Matters
In our consulting practice, we regularly observe that reporting is not always complete or accurate. Incorrect product classifications, incomplete reports or differing processes along the supply chain can result in reported data that does not fully reflect actual material flows. Furthermore, the reporting system does not allow retrospective reporting, for example in cases of late registration. Such factors can influence statistical evaluations and should be taken into account when interpreting the collection rate.
This does not mean that the low collection rate is not a serious issue. Germany is clearly failing to meet the applicable target. However, drawing immediate conclusions about the underlying causes or the effectiveness of the entire system based on a single figure would be an oversimplification.
What Does the Low Collection Rate Mean for Producers and Distributors?
Regardless of the ongoing policy discussions, companies must continue to comply with their existing obligations under the German Electrical and Electronic Equipment Act (ElektroG) and European WEEE legislation. Producers and other obligated economic operators should ensure in particular that:
-
Electrical and electronic equipment is registered correctly and on time.
-
Quantities placed on the market are reported completely and accurately.
-
Take-back and disposal obligations are fulfilled, and WEEE collected through companies' own take-back programmes is properly recorded and reported.
-
Labelling and information requirements are implemented.
-
Quantities associated with cross-border sales are correctly allocated and accounted for.
Accurate Quantity Reporting Is an Essential Part of Effective EPR Compliance
The current discussion surrounding Germany's WEEE collection rate also highlights a broader issue: A functioning circular economy requires not only effective take-back systems, but also a reliable data foundation.
Companies should therefore view their registration and quantity reporting obligations as more than just administrative requirements. Complete, accurate and traceable reporting data is essential for correctly reflecting material flows and reliably assessing the performance of existing systems.
Looking to Review Your EPR Obligations?
Bitkom Compliance Solutions supports companies in meeting their registration, reporting and take-back obligations for electrical and electronic equipment, batteries and packaging.